If you have an electricity single rate smart meter, the display will automatically show the reading. You might have to press a button to switch between the rates The display might change between the rates automatically Make sure you write down the numbers shown on the display for each rate, such as day or night, low or normal, Rate 1 or Rate 2, A1 or A2, R1 or R2. If there’s a decimal point, ignore anything after it. Write down the numbers shown on the display. These meters have a digital display screen. If the next dial is between 9 and 0, write down the number before the one the previous pointer was on If the next dial is between 0 and 1, write down the number that the previous pointer was on If a pointer is directly on a number, you’ll need to look at the next dial before you write anything down For example, if the pointer is between 9 and 0, write down 9, not 0 If a pointer is between two numbers, write down the lower number. You’ll need to check which way each dial turns before you read it If the first one turns clockwise, the next will turn anti-clockwise and so on. As you read from left to right, the dials will turn in opposite directions. On gas meters, ignore any numbers from the large dial, the dial marked 100 or any red dials. On electricity meters, ignore any numbers from red dials, dials with no pointer, dials with no numbers or dials marked 1/10.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |